SW-MOTECH rear bag Urban ABS 16-29 liters universal

Description

SW-Motech Top case/back case Urban ABS 16-29-liter

The lightweight alternative to top cases or the solid alternative to back cases.

Details:

• the a top case, it provides a robust bottom side and a lockable quick-fastener that perfectly fits the SW-Motech Street Rack and Adventure Rack
• as a back case, it comes with a slip- and vibration-resistant bottom made out of foam rubber and four strap bands for secure mounting on almost every seat and luggage rack
• long-lasting, light and solid due to 2.5-mm (bottom) and 2-mm (top)thick ABS-plastic with amounts of polyester
• volume can be increased in height as required by circumferential zipper
• with open volume expansion, the URBAN ABS Top case holds a helmet and more
• integrated straps to compress the luggage prevent the lid from fluttering
• theft protection through lockable zipper and supplied motorcycle bag lock
• the carrying handle allows for comfortable carrying with one hand
• reflective details for greater road safety
• the structured surface is easy to clean and scratch-resistant
• the space in the lid can be separated from the lower part - also through the lid - i.e. the contents remain in place even when the lid is opened;
• padded inner lining with pocket for storing the lock
• waterproof inner pocket included in the delivery
• the rear bag version is supplied with 4 loop straps, paint protection foil and eyelets for the license plate

Measurements (approx.):
16-29 liters of storage space (height variable) for one helmet and more
Length x width x height outside: 36 x 40.5 x 21.5-46 cm
Length x width x height inside: 34 x 37 x 18-35 cm
Length x width Carrying handle: 12 x 2.5 cm
Length maximum x width Loop strap (only for rear bag version): 78 x 2.5 cm
Weight version Top case/Tail bag:  2.2/2.1 kg

Options:

• for the top case version, suitable model-specific carriers (Street Rack order number 70000080200 and following, Adventure Rack order number 70000070000 and following)
• suitable side cases (order numbers 70250500060 and 70250500061)

Approval:
Top case and rear bags do not need to be approved; therefore, they do not require certification marks, expert assessments or vehicle type approvals.

Price per piece

Universal mounting version rear pocket:

• place the bag on the bench or on the carrier as desired
• always keep a distance of at least 5 cm to the exhaust and its off-gas - this applies to the bag as well as the fastening straps
• first, install the front straps (to frame tubes, footrest holders, etc.) so that your freedom of movement doesn't get hindered nor any parts subjected to ecessive pressure (e.g. rear fairing).
• pull it tightly so the bag holds its position and doesn't slip backwards
• look for each motorcycle loadable fastening points for the rear fastening belts
• these are mostly the license plate holders, handles, frame tubes, turn signal holders (if these are stable enough), etc.
• the fastening straps can be fastened on the right and on the left opposite each other - if this is not possible, you can also connect them together, thus creating a continuous strap from right to left - usually laid between
  number plate and its holder or splash guard
• the supplied brackets can also be screwed to the rear wheel with the license plate mounting (do not screw to the visible side of the license plate as it would otherwise be covered) - this results in two perfectly suitable lashing points 
• make sure that nothing is disconnected or put under too much tension here
• tighten the two fastening straps but leave the bag a bit loose
• check the desired position of the bag again and adjust it, if necessary
• tighten all 4 straps evenly so that the bag is stable and doesn't slip even when loaded
• secure the belt ends against fluttering
• always increase the speed carefully on the first rides or every time you load it anew