Highsider switch via light sensor for DRL E-BOX TYP 1

Description

Highsider switch via light sensor for daytime running light E-BOX TYPE 1

Switches automatically between low beam and daytime running light via a light sensor.

Details:

• almost every vehicle can be converted this way
• also motorcycles that no longer have an on/off switch for the low beam - this makes the use of retrofitted daytime running lights possible.
• the light sensor controls whether the low beam or daytime running light is switched on depending on the brightness of the surroundings
• if there is no daytime running light available, they are required separately
• 20-pole - for connection, knowledge of on-board electrics is an  advantage 
• Coming Home function - switches off the light only 30 seconds after the ignition has been switched off
• the control box can be glued at any position (adhesive assembly tape is not included in delivery) or screwed using the side eyelets
• the light sensor can be attached at any position

Measurements (approx.):
Case Length x Width with/without eyelets Height: 48 x 75/56 x 15 mm
Inside-Ø x Length eyelets: 3.5 x 12 mm
Sensor Length x Diameter: 20 x 12 mm
Cable length Sensor to Box: 60 cm
Cable length other cables from Box: 49 cm
Weight: 153 g

Cable conifiguration:
Red = supply voltage +
Orange = low beam to box
Blue = box to low beam
Pink = box to daytime running light
White = control lamp for daytime running light
Purple/Black = high beam in box
Green = box to high beam
Yellow/Green = position light in box
Brown = box to position light
Gray = programming cable
Black = ground -

Certification:
Switches do not require approval; therefore, no certification marks, expert assessments or general operating license.

Price per piece