Superbike handlebar 22mm 0229 alu 76x7,1cm anthracite

Description

Hashiru Superbike Handlebars Aluminum 22 mm 0229

You think your original handlebar is too narrow or just too high?
This is the classic handlebar with a comfortable width for your sporty and relaxed sitting position.

Details:

• made of high-strength aluminum tube with a strong wall for high stability
• brushed and anodized in high quality for long durability
• with ribbing in the clamping area and scaling in between to simplify alignment
• makes most models more manageable and gives you a great feeling of control on your bike
• suitable for handlebars with 22 mm outer diameter.

Measurements (approx.):
Width outer/inner edge: 761/751 mm
Height depending on position: 71-122 mm
Height depending on position: 71-122 mm
Offset to the rear depending on position: 102-150 mm
Maximum width in clamping area: 178 mm
Outer diameter: 22 mm
Inside diameter: 12 mm
Weight: 610 g

Options:

• Template for safe installation of the holes for the safety tiller to prevent the handlebar switches from turning (order number 50180808000)
• suitable Hashiru handlebar ends (order no. 60490000060 to 60490000066)

Certification (in Germany):
With vehicle type approval for many models (see attached PDF).
The provided vehicle type approval booklet must be carried along the ride.
A registration with the vehicle documents is possible for reasons of convenience, but not necessary.
WARNING: If your model is not listed in the supplied vehicle type approval, it will be used as a TÜV certificate - then a demonstration at the TÜV/Dekra is necessary upon consultation and immediately after the installation to get the confirmation of the proper installation and therefore the approval by individual approval required according to §19.2.

For our Swiss customers:
Please purchase this item in one of our Swiss branches, if possible.
Because of Swiss road traffic laws, you need a CH certificate (additional) for this technical item. This certificate can be obtained in one of our branches and will not be delivered with the item.
If you still wish to order this item online, please ensure that the motorcycle for which the component is intended is listed in the certificate accompanying the item. If this is not the case, the item is not eligible for return/exchange.
We will gladly answer any questions by e-mail or telephone via our hotline in Switzerland.

Price per piece

Assembly instructions:

The handlebars can only be installed on motorcycles that have suitable risers with a Ø22.2 mm handlebar clamp.
All cables and Bowden cables must be layed in a way that they are not bent or tensioned during any steering and deflection movements and that there is enough distance to chafing points.
The brake hoses must not have a bending radius of less than 40 mm. The engine speed must not vary to either side when the steering angle is turned fully and the engine is running.
All controls on the handlebars must be placed correctly, even when the steering angle is fully turned. The handbrake cylinder or reservoir tank must be in the proper working position.
Ensure that the handlebar, its attachments can move freely and that there is sufficient steering angle to each side. The handlebar must be moved easily from steering stop to steering stop.
After installation, a functional check of the brakes, clutch, throttle grip, lights and horn must be made.