LED running light indicatorpair ST08 M10 black, tinted glass
- Free shipping from 199,- €
- 450+ Motorcycle Parts
- 65.000+ products
Product description
Shipping & Return
Description
Hashiru LED chaser light turn signal pair ST08
Sequential LED turn signals with sequentially lit LED (intend called running effect) for increased safety through better conspicuousness in this flashing mode.
The ST08 show the glowing Led outward in an arrow shape, which once again increases the attention of the other road users.
Details:
- when activated, the LEDs go from the inside to the outside in succession until all the lights start again from the beginning
- the increased conspicuousness results in an increase in safety
- lightweight plastic case
- with long-lasting rubber foot against vibration
- mounting by M10x1.25 thread and nut
- 21 Glowing Led
- 12 Volt, 3.5 Watt
Measurements (approx.):
Width x height x depth without thread: 76 x 29 x 21 mm
Diameter foot: 16,5 mm
length of the thread: 17 mm
Lenght of the cable: 15 cm
Ø Circular Receptacles: 3,5 mm
Weight: je 33 g
Cable configuration:
yellow = plus turn signal
black = mass
WARNING:
When using LED turn signals on vehicles that don't have them in the original state, it may be necessary to replace the flasher relay and/or to reduce the flashing frequency to a permissible level by means of resistors.
Options:
- if the legal distances cannot be maintained, or simply the number plate is in the way, additionally it can be necessary to use suitable extensions for the turn signal arm (order numbers 50170400860, 50170400870 or 50170400871)
- for an easier connection, without make any changes to the cables, you can add adapter cables choosing one of this corresponding models made by different manifacturers, to the turn to the original signals (order number 50170003460 and following such as 50170502000 and next)
- if mounting is to be done instead of using the original turn signals, it will most likely be too big - for many manufacturers/models, there are suitable adapter plates with which mounting is then easier (Order No. 50170100000 and following)
- with the adjustable resistor even for models with CAN-BUS system easily usable (order number 50220000640)
Certification:
With CE certification mark for front and rear.
The turn signals have a CE certification mark and require no further paperwork.
Therefore, you can easily install them according to the mounting instructions without further ado.
For motorcycles with CE certification marks (from approx. mid/end of the 1990s):
STRONG>Minimum distance turn signal to turn signal front/rear is: 240/180 mm
Minimum distance turn signal to headlamp glass is: 75 mm
Maximum rear turn indicator distance to the far end of the tail: 300 mm
Allowed mounting height is between: 350 to 1200 mm
Geometric visibility to the inside/outside: 20/80 degrees
Geometric visibility to the top and bottom: 15 degrees
Allowed flashing frequency is: between 60 to 120 cycles per minute
For older models, for vehicles which have been put on the market individually or in non-EU member states, different dimensions can be applied.
Price per pair
Item No. 5731671020004170
About the brand
POLO Club members pay €3.99 to return your ordered goods, non-members pay €5.99. You can conveniently return them via DHL or hand them in at your nearest POLO store free of charge.
Simply use our returns portal at returns.polo-motorrad.com.